🧹

Cleaning & Sanitizing

Cleaning and sanitizing are distinct but equally important food safety processes. This topic covers the difference between cleaning (removing soil) and sanitizing (reducing pathogens), proper sanitizer concentrations, the three-compartment sink method, cleaning schedules, and equipment hygiene procedures.

42 questions | 10 easy, 24 medium, 8 hard
Q1/10
cleaning-sanitizingDifficulty: ●●●

How should food contact surfaces be cleaned if the water supply is temporarily cut off?

Key facts

  • Interior Health (BC): wash with hot soapy water, rinse, then sanitize; chlorine at 100–200 ppm (about 5 mL of 5% bleach per litre) or quats at 200–400 ppm per the manufacturer.(source)
  • Confirm sanitizer concentration with test strips, change bucket solutions every 2 hours or as needed, and clean and sanitize continuously used surfaces at least every 4 hours.(source)
  • BC food service establishments must have written sanitation procedures that list cleaning and sanitizing agents and their concentrations (s. 24).(source)

Common mistakes

Sanitizing a dirty surface does not work: food residue protects bacteria and uses up the chemical. The order is clean, rinse, sanitize, air dry. More bleach is not better, and chlorine test strips cannot measure quaternary ammonium.

Related reading

Sources and further reading (last reviewed November 2026)

Temperatures, training rules and fees are set by Health Canada, the CFIA, provincial governments and local public health units, and they change. Where this page states a regulatory fact, it is based on the official pages below. If anything here disagrees with them, the official source wins. You can read how we review and correct content.

Sample questions with answers

A few questions from this set, with the answer and explanation. The interactive quiz above draws from the full bank.

  1. 1. What is the difference between cleaning and sanitizing?

    • A. They are the same thing
    • B. Neither is important in food service
    • C. Sanitizing removes dirt; cleaning kills bacteria
    • D. Cleaning removes visible dirt and food residue; sanitizing reduces bacteria to safe levels
    Show answer

    Answer: D. Cleaning removes visible dirt and food residue; sanitizing reduces bacteria to safe levels

    Cleaning removes visible dirt, food particles, and grease. Sanitizing reduces bacteria and other pathogens to safe levels. Both steps are necessary — you must clean before you sanitize.

  2. 2. A three-compartment sink is used for:

    • A. Manual dishwashing: wash (with detergent), rinse (clean water), sanitize
    • B. Washing vegetables
    • C. Filling water glasses
    • D. Storing dirty dishes
    Show answer

    Answer: A. Manual dishwashing: wash (with detergent), rinse (clean water), sanitize

    The three-compartment sink system: Compartment 1 — wash with hot detergent water, Compartment 2 — rinse with clean water, Compartment 3 — sanitize with chemical or hot water.

  3. 3. How should wiping cloths be stored when not in use?

    • A. In your pocket
    • B. On the counter to air dry
    • C. In a bucket of sanitizer solution at the proper concentration
    • D. In the garbage
    Show answer

    Answer: C. In a bucket of sanitizer solution at the proper concentration

    When not in use, wiping cloths must be stored in a bucket of sanitizer solution at the correct concentration. This prevents them from spreading bacteria when used.

  4. 4. What are the signs of pest infestation in a food establishment?

    • A. Higher electricity bills
    • B. Droppings, gnaw marks, nesting materials, grease trails, dead insects, damaged packaging, and unusual odours
    • C. Increased customer complaints about taste
    • D. Equipment breaking down more frequently
    Show answer

    Answer: B. Droppings, gnaw marks, nesting materials, grease trails, dead insects, damaged packaging, and unusual odours

    Signs include droppings (rodents, cockroaches), gnaw marks, nesting materials, grease trails along walls, live or dead pests, damaged packaging, and unusual musty or ammonia-like odours.

  5. 5. What is the recommended minimum contact time for QUAT sanitizers?

    • A. No contact time needed
    • B. 5 seconds
    • C. At least 10 minutes
    • D. At least 45 seconds, or as the manufacturer directs
    Show answer

    Answer: D. At least 45 seconds, or as the manufacturer directs

    Ontario's manual dishwashing standard calls for soaking items for at least 45 seconds in QUAT at 200 ppm, in water at 24°C or warmer. Always follow the manufacturer's directions and your local rules.

  6. 6. How often should food contact surfaces be cleaned and sanitized during continuous use?

    • A. Once at the end of the day
    • B. Only when visibly dirty
    • C. Once a week
    • D. Between tasks and food types, and at regular intervals (often every 4 hours) during use
    Show answer

    Answer: D. Between tasks and food types, and at regular intervals (often every 4 hours) during use

    Clean and sanitize food contact surfaces between tasks, when switching food types (especially raw to ready-to-eat), whenever contaminated, and at regular intervals during continuous use. Many food codes use 4 hours as the longest interval.

This guide is free and kept up to date by one person.☕ Support it